I have multiple set of rockers that I will not be using. They are all used.
MiniSpares(Titan, but unmarked) full roller,-$350 1.3 - on hold for someone
Titan 1.5 full roller-$325,
MiniSpares Forged 1.5-$100, - on hold for someone
and standard sintered set- $30.
The gold colored set can be had for shipping. I believe it is a MiniSport 1.7 set. - on hold for someone
If interested send me a message. No one in the local club was interested, next stop here and then to the FB selling sites...
Not sure why the Titans are so expensive, but at one point they were the only full roller set available. Some are lightly used, the Titan 1.5s are well used, but still have lots of life left.
Shipping is not included in the listed prices.
Here is the set for the cost of shipping.
This set is gone!
1.7? that's a LOT of lift, you could only use those with a stock cam, I'd guess? and you'd have to use some shims under the stands?
When you say full roller, you mean both where the shaft goes and the tips?
Yes, full roller is roller tip and roller bearings for the shaft.
Message sent.. can also email communicate (these messages can be strange)
Jhandy59@gmail.com
Justin, I replied but I am not sure I got the email right. I sent it again.
Terry
He's on the east coast, so add 4 hours
Quote from: MiniDave on January 21, 2020, 09:00:30 PM
He's on the east coast, so add 4 hours
Four time zones, but just 3 hours difference.
We connected!